Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair Concentricity Gauge
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="nksmfamjp" data-source="post: 2373907" data-attributes="member: 1951"><p>Measured at the bullet tip, I'm trying to get under 0.003", but under 0.008" seems to shoot within my ability. I tried bullet tip adjustment</p><p></p><p>Measured at the case mouth, I'm shooting for 0.002". I get that with most dies when things are setup right. Be careful with this measurement. On std dies, this is best measured as a transfer measurement at the bullet close to the mouth.</p><p></p><p>Be cautious with tools like the Hornady tool. They are measuring with the wrong datum scheme. It is like measuring down the edge of a board, marking, then setting up the table saw to that mark. If the board is not square, your cut will be off.</p></blockquote><p></p>
[QUOTE="nksmfamjp, post: 2373907, member: 1951"] Measured at the bullet tip, I’m trying to get under 0.003”, but under 0.008” seems to shoot within my ability. I tried bullet tip adjustment Measured at the case mouth, I’m shooting for 0.002”. I get that with most dies when things are setup right. Be careful with this measurement. On std dies, this is best measured as a transfer measurement at the bullet close to the mouth. Be cautious with tools like the Hornady tool. They are measuring with the wrong datum scheme. It is like measuring down the edge of a board, marking, then setting up the table saw to that mark. If the board is not square, your cut will be off. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair Concentricity Gauge
Top