Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bumping issue now stuck case
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="vancewalker007" data-source="post: 2291198" data-attributes="member: 66917"><p>I'd be recording the following on fresh cases, fired cases and fired-sized cases. </p><p>- base to mid-shoulder length measurements</p><p>- Web diameter</p><p>- Over all case length, I'd trim about .001 under suggested trim to length just to be sure</p><p></p><p>The web area on the case can cause snugness on close, ran into this on my 6.5 PRC. If you don't have your bump set correctly the cases will sometimes not go into the die the correct distance to resize both the shoulder distance and the web area. I found with my setup I needed to bump this 6.5 PRC .004-.005 to get the whole case properly resized. It cured my web area size issue completely. I went through a bunch of fired cases moving the die down and up until I hit the sweet spot.</p></blockquote><p></p>
[QUOTE="vancewalker007, post: 2291198, member: 66917"] I'd be recording the following on fresh cases, fired cases and fired-sized cases. - base to mid-shoulder length measurements - Web diameter - Over all case length, I'd trim about .001 under suggested trim to length just to be sure The web area on the case can cause snugness on close, ran into this on my 6.5 PRC. If you don't have your bump set correctly the cases will sometimes not go into the die the correct distance to resize both the shoulder distance and the web area. I found with my setup I needed to bump this 6.5 PRC .004-.005 to get the whole case properly resized. It cured my web area size issue completely. I went through a bunch of fired cases moving the die down and up until I hit the sweet spot. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Shoulder bumping issue now stuck case
Top