Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
sheared base screws
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="CVCOBRA1" data-source="post: 1883333" data-attributes="member: 83906"><p>Use iso-alcohol to clean screw holes and screws from any possibility of oil. Also clean the bottom of rail and top of action. A drop of BLUE loctite on each screw and bottom of rail. Torque to spec. Can always be removed with a little heat. If that doesn't work then your screw are either too long or your holes are not tapped deep enough. Had an X-bolt where the latter was the case.</p></blockquote><p></p>
[QUOTE="CVCOBRA1, post: 1883333, member: 83906"] Use iso-alcohol to clean screw holes and screws from any possibility of oil. Also clean the bottom of rail and top of action. A drop of BLUE loctite on each screw and bottom of rail. Torque to spec. Can always be removed with a little heat. If that doesn't work then your screw are either too long or your holes are not tapped deep enough. Had an X-bolt where the latter was the case. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
sheared base screws
Top