Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Seekins Havak action / barrel threading
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="7070yshot" data-source="post: 2411256" data-attributes="member: 114427"><p>Ok so cut the threads, got it.</p><p>What is that notch in front of the shoulder? Doesn't show a dimension?</p><p></p><p>The 130 degree bevel at .625? I'm not sure how to measure/cut that. Since the center is floating in space. </p><p>And then did you just use the chamber reamer after that? Does it matter how much of that ends up being removed? </p><p></p><p>The other issue I had was based on the bolt being sloppy, there would be 50-60thou of brass that unsupported during firing. Is that not a concern?</p></blockquote><p></p>
[QUOTE="7070yshot, post: 2411256, member: 114427"] Ok so cut the threads, got it. What is that notch in front of the shoulder? Doesn’t show a dimension? The 130 degree bevel at .625? I’m not sure how to measure/cut that. Since the center is floating in space. And then did you just use the chamber reamer after that? Does it matter how much of that ends up being removed? The other issue I had was based on the bolt being sloppy, there would be 50-60thou of brass that unsupported during firing. Is that not a concern? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Seekins Havak action / barrel threading
Top