Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
seating depth problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RT2506" data-source="post: 497829" data-attributes="member: 10178"><p>You need to measure from the O-give of the bullet to the base of the case. You need a bullet comparator to do this. There a different types of comparators. Check them out at Midway PTG comparator product # 365-447 & 746-974 or Hornady product # 348-740 .</p><p></p><p>Bullet tips are different but the O-give is usually consistent in the same lot of bullets. Where you can run into problems is if the bullets came from different lots or were made on different machines.</p></blockquote><p></p>
[QUOTE="RT2506, post: 497829, member: 10178"] You need to measure from the O-give of the bullet to the base of the case. You need a bullet comparator to do this. There a different types of comparators. Check them out at Midway PTG comparator product # 365-447 & 746-974 or Hornady product # 348-740 . Bullet tips are different but the O-give is usually consistent in the same lot of bullets. Where you can run into problems is if the bullets came from different lots or were made on different machines. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
seating depth problem
Top