Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
seating 175 smk long
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arrow" data-source="post: 460012" data-attributes="member: 9798"><p>thanks for the help so far. i was going to firefore all brass anyway then set the fl sizer die to just bump the shoulder back .002" if this is happening, does it really matter what kind of reamer is used if the throat is cut to a certain depth? what i am trying to figure out her is is there any advantage to shooting the 175 smk seated to 2.99" instead of the standared 2.8 or so inches? would there be a great increase in the ablility to load hot? also is the 175 smk long enough to seat out to 2.99" with good neck tension? thanks</p></blockquote><p></p>
[QUOTE="arrow, post: 460012, member: 9798"] thanks for the help so far. i was going to firefore all brass anyway then set the fl sizer die to just bump the shoulder back .002" if this is happening, does it really matter what kind of reamer is used if the throat is cut to a certain depth? what i am trying to figure out her is is there any advantage to shooting the 175 smk seated to 2.99" instead of the standared 2.8 or so inches? would there be a great increase in the ablility to load hot? also is the 175 smk long enough to seat out to 2.99" with good neck tension? thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
seating 175 smk long
Top