Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Saw for cutting down brass??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="osprey176" data-source="post: 1998294" data-attributes="member: 30899"><p>I use a Harbor Freight mini chop saw to make 30 and 357 Herrett cases from 30/30 brass. I used a short piece of angle aluminum and a fine threaded bolt with a couple Nyloc nuts to make an adjustable jig. I drop the case in the V-notch and slide it against the bolt head,then cut. The whole works is mounted on a piece of 1x12. You can buy replacement blades from Amazon,the original won't last too long and you wind up using too much pressure and slowing down the saw. This will kill the motor,so keep a good blade and be gentle.</p></blockquote><p></p>
[QUOTE="osprey176, post: 1998294, member: 30899"] I use a Harbor Freight mini chop saw to make 30 and 357 Herrett cases from 30/30 brass. I used a short piece of angle aluminum and a fine threaded bolt with a couple Nyloc nuts to make an adjustable jig. I drop the case in the V-notch and slide it against the bolt head,then cut. The whole works is mounted on a piece of 1x12. You can buy replacement blades from Amazon,the original won’t last too long and you wind up using too much pressure and slowing down the saw. This will kill the motor,so keep a good blade and be gentle. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Saw for cutting down brass??
Top