Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Savage tenon thread LENGTH (small shank)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="SupressYourself" data-source="post: 2856706" data-attributes="member: 100820"><p>I'm having a problem headspacing a new custom barrel for a Savage Impulse. I have the barrel nut back as far as it will go (ran out of threads), and when the barrel is threaded into the receiver to where the nut hits, I still have about .020 headspace. I got to measuring the length of the threads (from breech to last thread), and the custom barrels are shorter.</p><p>Savage factory: ~1.600</p><p>Custom: ~ 1.550</p><p></p><p>I've done some research, and while large vs small shank / thread pitch specs are everywhere, I'm not finding much for what the LENGTH of those threads up the shank should be. I've seen both 1.600 and 1.550. <a href="https://en.wikipedia.org/wiki/Barrel_threads" target="_blank">This</a> says 42.06 mm, which would be 1.655. </p><p>Are my custom barrels just not threaded to spec, or is something else off?</p></blockquote><p></p>
[QUOTE="SupressYourself, post: 2856706, member: 100820"] I'm having a problem headspacing a new custom barrel for a Savage Impulse. I have the barrel nut back as far as it will go (ran out of threads), and when the barrel is threaded into the receiver to where the nut hits, I still have about .020 headspace. I got to measuring the length of the threads (from breech to last thread), and the custom barrels are shorter. Savage factory: ~1.600 Custom: ~ 1.550 I've done some research, and while large vs small shank / thread pitch specs are everywhere, I'm not finding much for what the LENGTH of those threads up the shank should be. I've seen both 1.600 and 1.550. [URL='https://en.wikipedia.org/wiki/Barrel_threads']This[/URL] says 42.06 mm, which would be 1.655. Are my custom barrels just not threaded to spec, or is something else off? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Savage tenon thread LENGTH (small shank)
Top