Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
The Basics, Starting Out
Running in a scope?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="earplay" data-source="post: 567862" data-attributes="member: 38054"><p>I just read an interesting magazine article here in NZ, suggesting that new scopes need ´running in´ similar to breaking in a barrel. The theory is that new scopes may have minor burrs on threads or small buildups of grease etc when fresh from the factory. The author suggested these mimor factors can cause a scope not to adjust precisely without either running past and then back to the desired dial or lightly tapping the scope after adjustments are made to settle reticle fully.</p><p> </p><p>He suggested the best method was to take a new scope and run through the full range of adjustment approx. 30 times prior to mounting. This included the windage/elevation dials, parallax and zoom rings. </p><p> </p><p>Can anyone else verify similar findings or heard anything similar? I am hoping to get a new scope soon and figure running the adjustments back and forth a few times can´t hurt?</p></blockquote><p></p>
[QUOTE="earplay, post: 567862, member: 38054"] I just read an interesting magazine article here in NZ, suggesting that new scopes need ´running in´ similar to breaking in a barrel. The theory is that new scopes may have minor burrs on threads or small buildups of grease etc when fresh from the factory. The author suggested these mimor factors can cause a scope not to adjust precisely without either running past and then back to the desired dial or lightly tapping the scope after adjustments are made to settle reticle fully. He suggested the best method was to take a new scope and run through the full range of adjustment approx. 30 times prior to mounting. This included the windage/elevation dials, parallax and zoom rings. Can anyone else verify similar findings or heard anything similar? I am hoping to get a new scope soon and figure running the adjustments back and forth a few times can´t hurt? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
The Basics, Starting Out
Running in a scope?
Top