Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
Ruger Mark II Stainless 243
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BLK" data-source="post: 430437" data-attributes="member: 27177"><p>Absolutely remember. The fore end at the front was very much in contact with the barrel. Then about 2 inches down toward the chamber the barrel hit the stock on the right. About four inches down it hit the left side of the stock on the upper edge of the stock. Two other places on left side and I ground all if it out to obtain a complete free float. Still only 2 inch three shot groups at 100 yards. It improved by </p><p>one half inch in other words. I had an old ruger 77 and had to tape a contact point at the very tip of the stock and barrel. Used electrical tape. Free floated the entire barrel then created this contact point and it went from 2 inch to sub 1/2 inch groups. </p><p>I am going to try this "contact point" to see if it will do the same.</p></blockquote><p></p>
[QUOTE="BLK, post: 430437, member: 27177"] Absolutely remember. The fore end at the front was very much in contact with the barrel. Then about 2 inches down toward the chamber the barrel hit the stock on the right. About four inches down it hit the left side of the stock on the upper edge of the stock. Two other places on left side and I ground all if it out to obtain a complete free float. Still only 2 inch three shot groups at 100 yards. It improved by one half inch in other words. I had an old ruger 77 and had to tape a contact point at the very tip of the stock and barrel. Used electrical tape. Free floated the entire barrel then created this contact point and it went from 2 inch to sub 1/2 inch groups. I am going to try this "contact point" to see if it will do the same. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
Ruger Mark II Stainless 243
Top