Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Rough chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="codyadams" data-source="post: 2506664" data-attributes="member: 87243"><p>No ejector mark, no swipe, rounded primer edges, rounded firing pin impact edges, no crater......</p><p></p><p>Terrible rings around the shoulder, obvious scratches in the chamber imprinted on the brass. </p><p></p><p>It's not pressure......once the smith fixes the chamber up right (hopeful for the op....) then that load will eject fine and without bolt lift. I'll up the stakes......20 primers!!!!! GM215M's too.....ha ha.</p></blockquote><p></p>
[QUOTE="codyadams, post: 2506664, member: 87243"] No ejector mark, no swipe, rounded primer edges, rounded firing pin impact edges, no crater...... Terrible rings around the shoulder, obvious scratches in the chamber imprinted on the brass. It's not pressure......once the smith fixes the chamber up right (hopeful for the op....) then that load will eject fine and without bolt lift. I'll up the stakes......20 primers!!!!! GM215M's too.....ha ha. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Rough chamber?
Top