Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Resizing reamer Specs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="can1010" data-source="post: 1988077" data-attributes="member: 43193"><p>stick with the reamer makers recommendations. if you don't think that brass will spring back .002 or more you need to look up all the problems the 6.5 PRC guys are having when they run upper end hunting loads. 3-4 loads on even ADG brass and they are getting stiff bolt lift and clickers. we have chamber cast the dies and they are set for .0035-.004 size at base but are only giving .001-.0015 of actual size because of spring back. leave well enough alone unless you are only running low end loads.</p></blockquote><p></p>
[QUOTE="can1010, post: 1988077, member: 43193"] stick with the reamer makers recommendations. if you don't think that brass will spring back .002 or more you need to look up all the problems the 6.5 PRC guys are having when they run upper end hunting loads. 3-4 loads on even ADG brass and they are getting stiff bolt lift and clickers. we have chamber cast the dies and they are set for .0035-.004 size at base but are only giving .001-.0015 of actual size because of spring back. leave well enough alone unless you are only running low end loads. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Resizing reamer Specs
Top