Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
ReSizing Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mconwa951" data-source="post: 840422" data-attributes="member: 20886"><p>Hey guys been awhile since I have been on here. I just finished building a new 300wsm and am getting ready to build a few loads for it. I have loaded a little in the past with some success but by no means an expert hence my question. </p><p> </p><p>So here it is I set up my dies according to the instructions as usual. Spun it down to the shell holder then went a 1/4 turn more and started resizing. I checked one of the empty cases in the chamber and it closes just fine no pressure needed or anything like that however when I go to pull the bolt back it is a little sticky and takes a tap or two nothing major but I am sure something isn't right. I checked with a mic and the only difference I can see is way in the back by the rim I get a reading on factory ammo of .547 and on my resized casing I get .553. Is this what is doing it and if so how do I correct doesn't seem like the FL sizing die even goes down that far.</p><p> </p><p>thanks in advance for any help you can give</p></blockquote><p></p>
[QUOTE="mconwa951, post: 840422, member: 20886"] Hey guys been awhile since I have been on here. I just finished building a new 300wsm and am getting ready to build a few loads for it. I have loaded a little in the past with some success but by no means an expert hence my question. So here it is I set up my dies according to the instructions as usual. Spun it down to the shell holder then went a 1/4 turn more and started resizing. I checked one of the empty cases in the chamber and it closes just fine no pressure needed or anything like that however when I go to pull the bolt back it is a little sticky and takes a tap or two nothing major but I am sure something isn't right. I checked with a mic and the only difference I can see is way in the back by the rim I get a reading on factory ammo of .547 and on my resized casing I get .553. Is this what is doing it and if so how do I correct doesn't seem like the FL sizing die even goes down that far. thanks in advance for any help you can give [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
ReSizing Question
Top