Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
resizing 7mm brass that wont chamber?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Lefty7mmstw" data-source="post: 979534" data-attributes="member: 48043"><p>there is a bit of vertical slop in the mechanism of a press. By setting your dies a bit low (to soak up this slop) you will fell a bit of resistance as the press goes to full stroke then it (the resistance) will come off the last few degrees of stroke when the press "cam's over". When you feel this resistance your dies are as low as they can go and people often just use "cam over" as a term to denote this.</p></blockquote><p></p>
[QUOTE="Lefty7mmstw, post: 979534, member: 48043"] there is a bit of vertical slop in the mechanism of a press. By setting your dies a bit low (to soak up this slop) you will fell a bit of resistance as the press goes to full stroke then it (the resistance) will come off the last few degrees of stroke when the press "cam's over". When you feel this resistance your dies are as low as they can go and people often just use "cam over" as a term to denote this. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
resizing 7mm brass that wont chamber?
Top