Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
Remington 700 Long Range 7mm Remington Magnum issues I
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WildRose" data-source="post: 1077634" data-attributes="member: 30902"><p>I've found a couple of easy ways to polish a chanber.</p><p></p><p>One is to use 0000 steel wool and lapping compound.</p><p></p><p>Wrap it around a piece pistol cleaning rod till it fits barely snugly in the chamber. Bathe id liberally in lapping compound and spin with a drill ten seconds or so at a time wiping clean and checking chambering in between.</p><p></p><p>The other is to use a piece of fired brass, mount it on a piece of rod by drilling the primer hole out to the diameter of the rod and using a little epoxy to secure the rod *same diameter as your bullet* to the neck. Let set overnight.</p><p></p><p>Bathe it in lapping compound and spin on a drill about 30 sec to 1 minute at a time, cleaning and checking chambering between rounds.</p><p></p><p>I've also had some very rough factory brass over the years and found the fastest way polish out the imperfections was to mount it in a drill using an RCBS base for case length trimming, 0000 steel wool, a drill and a little brasso.</p><p></p><p>15-30 seconds of spinning it in the drill would clean up the worst brass really quickly.</p></blockquote><p></p>
[QUOTE="WildRose, post: 1077634, member: 30902"] I've found a couple of easy ways to polish a chanber. One is to use 0000 steel wool and lapping compound. Wrap it around a piece pistol cleaning rod till it fits barely snugly in the chamber. Bathe id liberally in lapping compound and spin with a drill ten seconds or so at a time wiping clean and checking chambering in between. The other is to use a piece of fired brass, mount it on a piece of rod by drilling the primer hole out to the diameter of the rod and using a little epoxy to secure the rod *same diameter as your bullet* to the neck. Let set overnight. Bathe it in lapping compound and spin on a drill about 30 sec to 1 minute at a time, cleaning and checking chambering between rounds. I've also had some very rough factory brass over the years and found the fastest way polish out the imperfections was to mount it in a drill using an RCBS base for case length trimming, 0000 steel wool, a drill and a little brasso. 15-30 seconds of spinning it in the drill would clean up the worst brass really quickly. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
Remington 700 Long Range 7mm Remington Magnum issues I
Top