Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Remington 700 barrel and stock contact?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WapitiBob" data-source="post: 868268" data-attributes="member: 38015"><p>My factory SPS needed front end pressure after I set it in a new stock. The "always free float" mantra didn't hold up for me. </p><p>You could go in stages, checking groups on the factory setup, then epoxy the front pockets to stiffen it up, then bed some pillars and bed the action. Worst case you fubar a $20 stock. Best case it shoots and you get some bedding practice.</p></blockquote><p></p>
[QUOTE="WapitiBob, post: 868268, member: 38015"] My factory SPS needed front end pressure after I set it in a new stock. The "always free float" mantra didn't hold up for me. You could go in stages, checking groups on the factory setup, then epoxy the front pockets to stiffen it up, then bed some pillars and bed the action. Worst case you fubar a $20 stock. Best case it shoots and you get some bedding practice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Remington 700 barrel and stock contact?
Top