Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remington 700 ADL feeding issues rum and Nosler?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="IdahoCTD" data-source="post: 1866919" data-attributes="member: 13110"><p>If I was going down this road I would use a Wyatt and weld a small tab on the back so you can hold the box in the action like Remington does. The back of the box is about .280" thicker on the adl but it serves very little purpose. The follower spring is rounded in the back so it's not likely to catch under the rear of the box. If it does to can always add a small piece to the rear of the box.</p></blockquote><p></p>
[QUOTE="IdahoCTD, post: 1866919, member: 13110"] If I was going down this road I would use a Wyatt and weld a small tab on the back so you can hold the box in the action like Remington does. The back of the box is about .280" thicker on the adl but it serves very little purpose. The follower spring is rounded in the back so it's not likely to catch under the rear of the box. If it does to can always add a small piece to the rear of the box. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remington 700 ADL feeding issues rum and Nosler?
Top