Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remage question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tobnpr" data-source="post: 2009290" data-attributes="member: 68758"><p>Thread fitment tolerances as mentioned. </p><p>Smith could pick up the threads in your nut and open them up a bit to fit.</p><p></p><p>I hope that .06 barrel had a long full diameter breech. I don't know how much that barrel needed to be set back- but it was a substantial. If the chamber ends up partially in the taper- especially on a sporter contour hunting barrel it can be dangerous.</p></blockquote><p></p>
[QUOTE="tobnpr, post: 2009290, member: 68758"] Thread fitment tolerances as mentioned. Smith could pick up the threads in your nut and open them up a bit to fit. I hope that .06 barrel had a long full diameter breech. I don't know how much that barrel needed to be set back- but it was a substantial. If the chamber ends up partially in the taper- especially on a sporter contour hunting barrel it can be dangerous. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Remage question
Top