Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading same weight heads but with different manufacturers?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bingoc" data-source="post: 1837699" data-attributes="member: 38930"><p>All good advice from above and from folks that have experienced the differences that are inherent with various bullets i.e., ogive, bearing surface, alloy etc. I always use the manufacturers manual and start 5% lower that the lowest charge listed and work up in 1 grain increments until I see signs of excessive pressure. Be cautious and good luck.</p></blockquote><p></p>
[QUOTE="Bingoc, post: 1837699, member: 38930"] All good advice from above and from folks that have experienced the differences that are inherent with various bullets i.e., ogive, bearing surface, alloy etc. I always use the manufacturers manual and start 5% lower that the lowest charge listed and work up in 1 grain increments until I see signs of excessive pressure. Be cautious and good luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading same weight heads but with different manufacturers?
Top