Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading calipers?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ntsqd" data-source="post: 2068375" data-attributes="member: 93138"><p>I nearly always check zero on calipers, dial or digital, before every measurement. If they have left my hand, zero gets checked before the next measurement. I was trained to do that and it has become habit, one that I think is a good one to have.</p><p></p><p>Read on for a bit of a bio, maybe it adds context to my posts:</p><p></p><p>I'm not a Journeyman Machinist, I don't have the depth of training for that as that properly is years of apprenticeship. I did work as the "special projects" machinist/fabricator in a racing engines machine shop and under a retired Tool & Die machinist in a Vintage Racing & Touring car restoration/preparation shop during my undergrad years and for both on occasion since earning my Engineering degree. I think that I was about 7 or 8 when I made my first metal lathe project. That was more than a few decades ago.</p></blockquote><p></p>
[QUOTE="ntsqd, post: 2068375, member: 93138"] I nearly always check zero on calipers, dial or digital, before every measurement. If they have left my hand, zero gets checked before the next measurement. I was trained to do that and it has become habit, one that I think is a good one to have. Read on for a bit of a bio, maybe it adds context to my posts: I'm not a Journeyman Machinist, I don't have the depth of training for that as that properly is years of apprenticeship. I did work as the "special projects" machinist/fabricator in a racing engines machine shop and under a retired Tool & Die machinist in a Vintage Racing & Touring car restoration/preparation shop during my undergrad years and for both on occasion since earning my Engineering degree. I think that I was about 7 or 8 when I made my first metal lathe project. That was more than a few decades ago. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading calipers?
Top