Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Lug Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Muddyboots" data-source="post: 1874948" data-attributes="member: 63925"><p>Thanks guys, I knew I would get good feedback and appreciate it. I plan on marking the lug for contact and will bed as needed. I was thinking of increasing size but now am satisfied AOK with what I have from OEM.</p><p></p><p>Birdiemc: I found a few spots as well in the Magpul stock and the trigger guard for the DM was actually hitting the Timney trigger where there was a small pin through the top of trigger so had to notch out the spot in the trigger guard. Just enough pressure that it was affecting the trigger poundage adjustment. Drove me nuts until I spotted the contact. Also had to increase the trigger space to accommodate the larger shoe of the Timney so it didn't drag. Jury is still out on this stock so far and thinking about swap out if I can't get it to settle down a bit more. The action screw channels are quite large and I didn't like that there wasn't a solid support of the screw in the assigned space so I sleeved it and now the screw doesn't move at all in their assigned spaces of the stock. Torqued to 60 inch pounds to max out stock to action. You always have to do a little work on drop ins so not surprised in this case.</p></blockquote><p></p>
[QUOTE="Muddyboots, post: 1874948, member: 63925"] Thanks guys, I knew I would get good feedback and appreciate it. I plan on marking the lug for contact and will bed as needed. I was thinking of increasing size but now am satisfied AOK with what I have from OEM. Birdiemc: I found a few spots as well in the Magpul stock and the trigger guard for the DM was actually hitting the Timney trigger where there was a small pin through the top of trigger so had to notch out the spot in the trigger guard. Just enough pressure that it was affecting the trigger poundage adjustment. Drove me nuts until I spotted the contact. Also had to increase the trigger space to accommodate the larger shoe of the Timney so it didn't drag. Jury is still out on this stock so far and thinking about swap out if I can't get it to settle down a bit more. The action screw channels are quite large and I didn't like that there wasn't a solid support of the screw in the assigned space so I sleeved it and now the screw doesn't move at all in their assigned spaces of the stock. Torqued to 60 inch pounds to max out stock to action. You always have to do a little work on drop ins so not surprised in this case. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Lug Question
Top