Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
rechambered
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1812654" data-attributes="member: 2736"><p>^^^^ What he said.</p><p>It could end up costing more in the end and you would end up with a a factory barrel of less quality and potential.</p><p></p><p>Your smith can match the contour of the factory barrel and there would little if any stock work if you went with a new custom barrel. You would end up with a new and better barrel and would not spend as much for the smithing on a new barrel as apposed to a reused factory barrel that he would first have to be stripped, remove the tenon, set the shoulder back, and changing the barrel profile and fit of the stock. </p><p>Then he would have to do the same work on the new barrel as the used one minus</p><p>the stock work.</p><p></p><p>So the answer to your question is Yes, but at what cost and the outcome.</p><p></p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1812654, member: 2736"] ^^^^ What he said. It could end up costing more in the end and you would end up with a a factory barrel of less quality and potential. Your smith can match the contour of the factory barrel and there would little if any stock work if you went with a new custom barrel. You would end up with a new and better barrel and would not spend as much for the smithing on a new barrel as apposed to a reused factory barrel that he would first have to be stripped, remove the tenon, set the shoulder back, and changing the barrel profile and fit of the stock. Then he would have to do the same work on the new barrel as the used one minus the stock work. So the answer to your question is Yes, but at what cost and the outcome. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
rechambered
Top