Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
recessed crown under barrel threads?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Trickymissfit" data-source="post: 943845" data-attributes="member: 25383"><p>you can also simply cut holes in the end of the barrel with an EDM. It adds or relives very little if any stress in the barrel, and leaves very little if any burr in the bore. The problem is finding an EDM big enough to do it (they're out there), and the cost maybe be a good bit more due it being a little on the slow side (cuts about .06" a minute). The good part is that you can cut the non symmetrical holes that some folks this are best. </p><p>gary</p></blockquote><p></p>
[QUOTE="Trickymissfit, post: 943845, member: 25383"] you can also simply cut holes in the end of the barrel with an EDM. It adds or relives very little if any stress in the barrel, and leaves very little if any burr in the bore. The problem is finding an EDM big enough to do it (they're out there), and the cost maybe be a good bit more due it being a little on the slow side (cuts about .06" a minute). The good part is that you can cut the non symmetrical holes that some folks this are best. gary [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
recessed crown under barrel threads?
Top