Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Re-reaming a chamber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Rflshootr" data-source="post: 2870159" data-attributes="member: 10284"><p>It depends on the reason for the needed adjustment and if the same reamer is being used that originally cut the chamber. If it is a different reamer, I always set it back the length of the neck just so there aren't any steps in the neck to cause problems later. Additionally, if the round count on the barrel is fairly low, you get a fresh throat to start with. I will give this piece of advice, make sure every bit of carbon is cleaned out before the reamer ever gets inserted into the chamber.</p></blockquote><p></p>
[QUOTE="Rflshootr, post: 2870159, member: 10284"] It depends on the reason for the needed adjustment and if the same reamer is being used that originally cut the chamber. If it is a different reamer, I always set it back the length of the neck just so there aren't any steps in the neck to cause problems later. Additionally, if the round count on the barrel is fairly low, you get a fresh throat to start with. I will give this piece of advice, make sure every bit of carbon is cleaned out before the reamer ever gets inserted into the chamber. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Re-reaming a chamber
Top