Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Ramblings and Such From Hunting Coyote
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="74honker" data-source="post: 2790416" data-attributes="member: 113930"><p>While I know I'm OCD about alot of stuff, my brass prep is KISS. I full length size but only as much as needed to chamber easy. Trim when needed, usually after 2nd firing on new to square all back up. Tumble clean every firing before anything else is done. I use one shot lube and spray inside necks too and that's all I do to the necks. I do have a couple micrometer seating dies otherwise just a normal seating die. I'm debating whether to try annealing and have a setup made to do it open flame just haven't done it yet. Not near the work windypants or Dave are doing but my main go to will do bugholes all day if I do my part and so far on my latest project showing it will to. I'm sure I'll have to pay the piper someday when I run into an issue of somekind but so far been pretty lucky.</p></blockquote><p></p>
[QUOTE="74honker, post: 2790416, member: 113930"] While I know I'm OCD about alot of stuff, my brass prep is KISS. I full length size but only as much as needed to chamber easy. Trim when needed, usually after 2nd firing on new to square all back up. Tumble clean every firing before anything else is done. I use one shot lube and spray inside necks too and that's all I do to the necks. I do have a couple micrometer seating dies otherwise just a normal seating die. I'm debating whether to try annealing and have a setup made to do it open flame just haven't done it yet. Not near the work windypants or Dave are doing but my main go to will do bugholes all day if I do my part and so far on my latest project showing it will to. I'm sure I'll have to pay the piper someday when I run into an issue of somekind but so far been pretty lucky. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Ramblings and Such From Hunting Coyote
Top