Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Questions about my drop chart
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bigngreen" data-source="post: 1848811" data-attributes="member: 13632"><p>Usually around that 600 yard range will be where you start seeing things start to go of the rails if your not quite right.</p><p></p><p>You gotta nail your enviromentals first, you then need to give your calculator good data, shooting chrony's will leave your some room for tweeking so make sure everything else is nailed. Scope hight, range to target, BC, turret value, then you can concentrate one basically zero and velocity.</p><p>It's easiest to verify your zero is solid by shooting at 300 on paper, if your zero is of a little it'll show because velocity or BC isn't really visible yet so I tune my zero hight to match what it should be. </p><p>Then put up paper at, 300, 600 and 1000 and I dial and shoot these fast one round at each as close to the same condition as possible.</p><p>Measure it up and tune your velocity, I can usually get a solid tune to 1500 yards inside 20 rounds with this method.</p></blockquote><p></p>
[QUOTE="bigngreen, post: 1848811, member: 13632"] Usually around that 600 yard range will be where you start seeing things start to go of the rails if your not quite right. You gotta nail your enviromentals first, you then need to give your calculator good data, shooting chrony's will leave your some room for tweeking so make sure everything else is nailed. Scope hight, range to target, BC, turret value, then you can concentrate one basically zero and velocity. It's easiest to verify your zero is solid by shooting at 300 on paper, if your zero is of a little it'll show because velocity or BC isn't really visible yet so I tune my zero hight to match what it should be. Then put up paper at, 300, 600 and 1000 and I dial and shoot these fast one round at each as close to the same condition as possible. Measure it up and tune your velocity, I can usually get a solid tune to 1500 yards inside 20 rounds with this method. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Questions about my drop chart
Top