Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
question about neck turning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dmax1800" data-source="post: 991759" data-attributes="member: 68255"><p>I'm new to neck turning and am wondering about the steps.</p><p>I'm going to FL resize without the expander ball. Then trim each case to the same length. Then debur the case mouth. Then run expander mandrel and immediately turn the neck so that the mouth can't spring back.</p><p>Would it be a good idea to anneal the brass before FL resizing them??? I only have 2 firings on them since they were annealed, so I don't need to anneal them for just that reason.</p></blockquote><p></p>
[QUOTE="dmax1800, post: 991759, member: 68255"] I'm new to neck turning and am wondering about the steps. I'm going to FL resize without the expander ball. Then trim each case to the same length. Then debur the case mouth. Then run expander mandrel and immediately turn the neck so that the mouth can't spring back. Would it be a good idea to anneal the brass before FL resizing them??? I only have 2 firings on them since they were annealed, so I don't need to anneal them for just that reason. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
question about neck turning
Top