Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Question about neck sizing dies?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="chrisC" data-source="post: 549347" data-attributes="member: 6047"><p>I have a few questions about the various neck sizing dies including the bushing style. I have and used the redding type s neck bushing die for my 280remington and other 30/06 type cartridges. After a few firings you need to bump that shoulder back down using the neck die followed by the body die. When working with 40-60 pieces of brass I dont mind having to run my brass twice through the neck die followed by the body die. But my problem is when reloading for my various .17 and .22 cartridges I use for varmint hunting I am working with 500+ pieces of brass from several rifles and I want to eliminate the need to run that much brass through the dies twice.</p><p></p><p>I just want to know if its possible to use the redding full length bushing die and have it adjusted to where it sizes the necks and pushes the shoulder back just a few thousands or am I just better off sticking with the neck and body die? I am also looking at forsters bushing bump neck sizing die as well. They claim this die sizes the necks and shoulders of the case in one step. Do any of you have any experiences with this die?</p><p></p><p>I want to know cause I also plan to load just my varmint cartridges on a progressive press in the near future and it would be much easier if I didn"t have to use two sizing dies?</p></blockquote><p></p>
[QUOTE="chrisC, post: 549347, member: 6047"] I have a few questions about the various neck sizing dies including the bushing style. I have and used the redding type s neck bushing die for my 280remington and other 30/06 type cartridges. After a few firings you need to bump that shoulder back down using the neck die followed by the body die. When working with 40-60 pieces of brass I dont mind having to run my brass twice through the neck die followed by the body die. But my problem is when reloading for my various .17 and .22 cartridges I use for varmint hunting I am working with 500+ pieces of brass from several rifles and I want to eliminate the need to run that much brass through the dies twice. I just want to know if its possible to use the redding full length bushing die and have it adjusted to where it sizes the necks and pushes the shoulder back just a few thousands or am I just better off sticking with the neck and body die? I am also looking at forsters bushing bump neck sizing die as well. They claim this die sizes the necks and shoulders of the case in one step. Do any of you have any experiences with this die? I want to know cause I also plan to load just my varmint cartridges on a progressive press in the near future and it would be much easier if I didn"t have to use two sizing dies? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Question about neck sizing dies?
Top