Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
procedure for measuring case volume
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Trickymissfit" data-source="post: 945146" data-attributes="member: 25383"><p>the vapors or fumes from the stuff are pretty bad, but not as bad as most folks think.</p><p>The reason why is because of the old vapor cleaning machines. They work off heated Tch 1.1. with the vapors penetrating into everything. The vapors are known to be much heavier than air, so they stay in the pit or tank. But also will kill you! In an ultrasonic cleaning device, you just keep the lid on it. Then take it outside when emptying.</p><p> </p><p>You'll also find that most electricians that service DC and solid state stuff will be using it. DC wants a very clean contact, and low voltage solid state stuff needs it as well. The reason why? It leaves no residue when it dries. It's also the best cutting fluid money can buy for tapping small threads accurately (good for reaming small holes too). You often see it in tool rooms under the name of Tapmatic.</p><p>gary</p></blockquote><p></p>
[QUOTE="Trickymissfit, post: 945146, member: 25383"] the vapors or fumes from the stuff are pretty bad, but not as bad as most folks think. The reason why is because of the old vapor cleaning machines. They work off heated Tch 1.1. with the vapors penetrating into everything. The vapors are known to be much heavier than air, so they stay in the pit or tank. But also will kill you! In an ultrasonic cleaning device, you just keep the lid on it. Then take it outside when emptying. You'll also find that most electricians that service DC and solid state stuff will be using it. DC wants a very clean contact, and low voltage solid state stuff needs it as well. The reason why? It leaves no residue when it dries. It's also the best cutting fluid money can buy for tapping small threads accurately (good for reaming small holes too). You often see it in tool rooms under the name of Tapmatic. gary [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
procedure for measuring case volume
Top