Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Problems with ADL 300 WIN MAG
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="IdahoCTD" data-source="post: 1069149" data-attributes="member: 13110"><p>Do you have primers that are protruding around where the firing pin strikes? Is this with used brass only? Usually the primary extraction is OK if it hasn't been messed with. My guess is your sizing die isn't sizing enough just ahead of the belt so it's sticking a bit. I have seen where the bolt will have a sloppy firing pin hole and the primers will crater a bit causing stocky extraction sometimes too.</p></blockquote><p></p>
[QUOTE="IdahoCTD, post: 1069149, member: 13110"] Do you have primers that are protruding around where the firing pin strikes? Is this with used brass only? Usually the primary extraction is OK if it hasn't been messed with. My guess is your sizing die isn't sizing enough just ahead of the belt so it's sticking a bit. I have seen where the bolt will have a sloppy firing pin hole and the primers will crater a bit causing stocky extraction sometimes too. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Problems with ADL 300 WIN MAG
Top