Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Problem with belt cartridge
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tikkamike" data-source="post: 551245" data-attributes="member: 22242"><p>Here is your problem! My dad read this and instantly knew the problem and after he said it I knew he was right. Your decapping pin is down too far. the sizing button is hitting the other side of your primer pocket... pull loosen your stem and back it all the way out. and run your brass throught the die. should go in no problem. then take a piece of fired brass with the primer still and push it all the way in the die and leave the handle on your press in the down position. screw your depriming pin down until you feel it make contact. then pull the handle of the press back up and screw the pin in 2-3 turns and see if the primer comes out. if not give it a half turn and try again. keep going till it deprimes. then tighten the stem back up so it doesnt move. you should be good to go from there and no need to buy any dies.</p></blockquote><p></p>
[QUOTE="Tikkamike, post: 551245, member: 22242"] Here is your problem! My dad read this and instantly knew the problem and after he said it I knew he was right. Your decapping pin is down too far. the sizing button is hitting the other side of your primer pocket... pull loosen your stem and back it all the way out. and run your brass throught the die. should go in no problem. then take a piece of fired brass with the primer still and push it all the way in the die and leave the handle on your press in the down position. screw your depriming pin down until you feel it make contact. then pull the handle of the press back up and screw the pin in 2-3 turns and see if the primer comes out. if not give it a half turn and try again. keep going till it deprimes. then tighten the stem back up so it doesnt move. you should be good to go from there and no need to buy any dies. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Problem with belt cartridge
Top