Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Primer Pocket Restoration
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Edd" data-source="post: 1506690" data-attributes="member: 30592"><p>I have an idea. I don't know if it will work because I haven't tried it. It would be fun to try even if it doesn't work. </p><p></p><p>Buy a 300 H&H sizing die. Cut the threaded end off of the die. Now that you have both ends open, very carefully measure the ID and find the place where the ID is about .470", or whatever size you desire, and either drill out or cut off the die at that spot. Now you can screw that die stub in your press, find a good 7/16" pin of the correct length, and push your cases thru the stub.</p></blockquote><p></p>
[QUOTE="Edd, post: 1506690, member: 30592"] I have an idea. I don't know if it will work because I haven't tried it. It would be fun to try even if it doesn't work. Buy a 300 H&H sizing die. Cut the threaded end off of the die. Now that you have both ends open, very carefully measure the ID and find the place where the ID is about .470", or whatever size you desire, and either drill out or cut off the die at that spot. Now you can screw that die stub in your press, find a good 7/16" pin of the correct length, and push your cases thru the stub. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Primer Pocket Restoration
Top