Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Pretty sure it's a newb question..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mikecr" data-source="post: 669006" data-attributes="member: 1521"><p>I've never had a case fail.</p><p>I do set pieces aside that no longer hold a normal shoulder bump, or show abnormal seating forces.</p><p>These will be stress relieved when/if I do the whole batch.</p><p></p><p>The qualifiers:</p><p>-I don't mess with used factory brass at all</p><p>-I don't run excess pressures</p><p>-My cartridges include reduced body taper, higher shoulder angles(except my 223s)</p><p>-I don't FL size -ever, but minimally/partially body/neck size with custom dies</p><p>-my chambers are not loose</p><p></p><p>The benefits:</p><p>-Little to no trimming</p><p>-No need for annealing</p><p>-very low runout</p><p>-no donut forming</p><p>-very consistent neck tension</p><p>-very consistent H20 capacities</p><p>-seemingly endless brass life</p><p>-Very low ES</p><p>-easy case extraction</p><p>-below and consistent 1/2moa with every gun I've had</p></blockquote><p></p>
[QUOTE="Mikecr, post: 669006, member: 1521"] I've never had a case fail. I do set pieces aside that no longer hold a normal shoulder bump, or show abnormal seating forces. These will be stress relieved when/if I do the whole batch. The qualifiers: -I don't mess with used factory brass at all -I don't run excess pressures -My cartridges include reduced body taper, higher shoulder angles(except my 223s) -I don't FL size -ever, but minimally/partially body/neck size with custom dies -my chambers are not loose The benefits: -Little to no trimming -No need for annealing -very low runout -no donut forming -very consistent neck tension -very consistent H20 capacities -seemingly endless brass life -Very low ES -easy case extraction -below and consistent 1/2moa with every gun I've had [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Pretty sure it's a newb question..
Top