Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Pressure signs on 7mm SAUM... is there something else causing this?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="25WSM" data-source="post: 1711903" data-attributes="member: 38048"><p>One other cause could be the ejector is not going flush with the bolt face. To check this put bolt in a vise and push the ejector down all the way. Then check if it sits flush or below or above the bolt face. As long as it doesn't sit above its not a length issue. If it is too long remove it and cut the pin slot longer on the top. This will let it sit lower. Very small amount is all that is required.</p><p>Shep</p></blockquote><p></p>
[QUOTE="25WSM, post: 1711903, member: 38048"] One other cause could be the ejector is not going flush with the bolt face. To check this put bolt in a vise and push the ejector down all the way. Then check if it sits flush or below or above the bolt face. As long as it doesn't sit above its not a length issue. If it is too long remove it and cut the pin slot longer on the top. This will let it sit lower. Very small amount is all that is required. Shep [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Pressure signs on 7mm SAUM... is there something else causing this?
Top