Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Powder scale or e-scale? that is the question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RustyRick" data-source="post: 830095" data-attributes="member: 69572"><p>Thanks for the response ya'll. I used the RCBS 1010 for a lot of years and loved it. </p><p> </p><p>However, I think that unless your disciplined to make sure the beam is bouncing equally above and below the center or zero line it will have as much spread as any e-scale. Just cause it's off bottom doesn't mean your on target.</p><p> </p><p>My second question was how much tolerance might you allow in powder weight when working up load recipes? Is say .2 acceptable? Is that a significant difference to through MV hence accuracy out?</p></blockquote><p></p>
[QUOTE="RustyRick, post: 830095, member: 69572"] Thanks for the response ya'll. I used the RCBS 1010 for a lot of years and loved it. However, I think that unless your disciplined to make sure the beam is bouncing equally above and below the center or zero line it will have as much spread as any e-scale. Just cause it's off bottom doesn't mean your on target. My second question was how much tolerance might you allow in powder weight when working up load recipes? Is say .2 acceptable? Is that a significant difference to through MV hence accuracy out? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Powder scale or e-scale? that is the question
Top