Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Post Your Reloading Bench Pictures
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jrock" data-source="post: 1166610" data-attributes="member: 78569"><p>I just packed mine up, getting ready to move. I made a simple one out of plywood, 2x2, 2x4, 2x6, and 1x4. Probably cost $25</p><p> </p><p>I used 2x6 for the rear legs to flyby the working level to be shelves above. I used a router to slot holes in the 2x6 to allow the plywood shelves to slide in and be modular for powder cans, books, bullets, and little sorting bins. The working level is about 20" deep and 4' long and framed out with 2x4's and plywood. The front legs are 2x2 and everything is braced with 1x4s. </p><p> </p><p>The tricks I used were to recess some nuts in the table top to allow the bolts for the press to be unscrewed and still stay attached to the table. That way they never get lost and can provide a completely flat working area as well. I also notched the bottom of the legs to rest firmly on carpet and used two 2x4x12 concrete pavers as a weight under the press as the overall bench is quite light. Easy take down and assembly too.</p></blockquote><p></p>
[QUOTE="jrock, post: 1166610, member: 78569"] I just packed mine up, getting ready to move. I made a simple one out of plywood, 2x2, 2x4, 2x6, and 1x4. Probably cost $25 I used 2x6 for the rear legs to flyby the working level to be shelves above. I used a router to slot holes in the 2x6 to allow the plywood shelves to slide in and be modular for powder cans, books, bullets, and little sorting bins. The working level is about 20" deep and 4' long and framed out with 2x4's and plywood. The front legs are 2x2 and everything is braced with 1x4s. The tricks I used were to recess some nuts in the table top to allow the bolts for the press to be unscrewed and still stay attached to the table. That way they never get lost and can provide a completely flat working area as well. I also notched the bottom of the legs to rest firmly on carpet and used two 2x4x12 concrete pavers as a weight under the press as the overall bench is quite light. Easy take down and assembly too. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Post Your Reloading Bench Pictures
Top