Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Opinions on borescope video requested
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ndking1126" data-source="post: 2194789" data-attributes="member: 26820"><p>Unfired outside diameter at top of neck was .2905-.2910 and fired it was .2960-.2965, so looks good on expansion being more than .004".</p><p></p><p>Necks were kind of all over the place. The one in the middle was the lowest I found, and it ended right where the neck and shoulders meet. All the rest looked something like the other two or like the cases in your picture. The carbon didn't go as low the shoulder on any but that one piece.</p></blockquote><p></p>
[QUOTE="ndking1126, post: 2194789, member: 26820"] Unfired outside diameter at top of neck was .2905-.2910 and fired it was .2960-.2965, so looks good on expansion being more than .004". Necks were kind of all over the place. The one in the middle was the lowest I found, and it ended right where the neck and shoulders meet. All the rest looked something like the other two or like the cases in your picture. The carbon didn't go as low the shoulder on any but that one piece. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Opinions on borescope video requested
Top