Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
The Basics, Starting Out
Once Fired Brass Prep
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ajkellerusmc" data-source="post: 1829948" data-attributes="member: 108702"><p>I am going to start neck turning and neck tension adjustments. I have pretty much done everything else except annealing. I have all the tooling including the micrometer seating dies and concentricity tool for finished rounds. I had one group that measured .120 in the 6.5 which was pure coincidence as consistent groups are .600 to .750 right now. I would say average ES and SD are currently around 33/14 so with neck turning and tension adjustments I hope to get it down about half of those figures.</p><p></p><p>thanks</p></blockquote><p></p>
[QUOTE="ajkellerusmc, post: 1829948, member: 108702"] I am going to start neck turning and neck tension adjustments. I have pretty much done everything else except annealing. I have all the tooling including the micrometer seating dies and concentricity tool for finished rounds. I had one group that measured .120 in the 6.5 which was pure coincidence as consistent groups are .600 to .750 right now. I would say average ES and SD are currently around 33/14 so with neck turning and tension adjustments I hope to get it down about half of those figures. thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
The Basics, Starting Out
Once Fired Brass Prep
Top