Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Norma Brass Question - 7mm mag
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Juano86" data-source="post: 1341271" data-attributes="member: 102490"><p>G'day All,</p><p></p><p>I did a bit of a search on the subject but couldn't find what i was after, so pardon if this has been covered.</p><p>I Just purchased a new T3X Superlite in 7mm Mag and im just beginning to work up some loads. However, in my reloading manual it suggests that if using Norma Brass to reduce the powder by 10% to counter the heavier brass. Is this something i should be wary of? </p><p>Im using ADI AR-2217 powder (Not sure what the US equivalent is, ADI are saying its close to Hodgdon H1000). A max load for a 140gr projectile was 70gr, but shaving 10% seems like a lot. to develop the load id obviously use the ladder method and check for pressure signs etc. but reading that note made me wonder...</p><p></p><p>Any advice? Struggling to get RE-22 over here (in Australia), that would have been my first choice as a starting point. </p><p></p><p>Cheers in advance.</p></blockquote><p></p>
[QUOTE="Juano86, post: 1341271, member: 102490"] G'day All, I did a bit of a search on the subject but couldn't find what i was after, so pardon if this has been covered. I Just purchased a new T3X Superlite in 7mm Mag and im just beginning to work up some loads. However, in my reloading manual it suggests that if using Norma Brass to reduce the powder by 10% to counter the heavier brass. Is this something i should be wary of? Im using ADI AR-2217 powder (Not sure what the US equivalent is, ADI are saying its close to Hodgdon H1000). A max load for a 140gr projectile was 70gr, but shaving 10% seems like a lot. to develop the load id obviously use the ladder method and check for pressure signs etc. but reading that note made me wonder... Any advice? Struggling to get RE-22 over here (in Australia), that would have been my first choice as a starting point. Cheers in advance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Norma Brass Question - 7mm mag
Top