Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
New Brass Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="epags" data-source="post: 2074604" data-attributes="member: 105138"><p>I am confused by both comments. Why would you want cam over on a seater die? (Sizing die yes.) My RCBS instructions say to put a primed shell into the holder, run it to the top of the press stroke. Screw the seater die into the press until it just touches the mouth of the case AND THEN back the seater die off one full turn so that there is about 1/16" between the bottom of the die and the shell holder. Are Creedmoor dies designed to operate different than RCBS dies?</p></blockquote><p></p>
[QUOTE="epags, post: 2074604, member: 105138"] I am confused by both comments. Why would you want cam over on a seater die? (Sizing die yes.) My RCBS instructions say to put a primed shell into the holder, run it to the top of the press stroke. Screw the seater die into the press until it just touches the mouth of the case AND THEN back the seater die off one full turn so that there is about 1/16" between the bottom of the die and the shell holder. Are Creedmoor dies designed to operate different than RCBS dies? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
New Brass Problem
Top