Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
New Barrel Vise, it’s been a slow day….
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TonyDWisco" data-source="post: 2485400" data-attributes="member: 122477"><p>Honestly not sure.... Im going to say yes though as the bushing is made for a specific barrel shank and only has an additional .010" clearance for some drywall tape. I think if the bushings were generic and you had a bunch of extra space that was going to crush the bushing, then you would run into issues. I will make custom bushings as I need them, takes a min to change the cad for the ID and off the CNC turning center.</p></blockquote><p></p>
[QUOTE="TonyDWisco, post: 2485400, member: 122477"] Honestly not sure.... Im going to say yes though as the bushing is made for a specific barrel shank and only has an additional .010" clearance for some drywall tape. I think if the bushings were generic and you had a bunch of extra space that was going to crush the bushing, then you would run into issues. I will make custom bushings as I need them, takes a min to change the cad for the ID and off the CNC turning center. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
New Barrel Vise, it’s been a slow day….
Top