Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need suggestions on brass going into sizing die very hard
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="sambo3006" data-source="post: 373100" data-attributes="member: 2740"><p>Well, I finally got the cases to go all the way into the die. I made sure there was plenty of sizing wax and short stroked the cases in and out until they were all the way in. After about 15 cases it is somewhat easier but still takes a fair amount of force and short strokes. There might be something to having cleaned out all the lube from the die initially, or maybe the repeated strokes with the cases have lapped the interior of the die a little bit. Either way I am glad that I can resize my cases but I wish there weren't quite so much resistance. Maybe it will get better as I run more cases through it.</p></blockquote><p></p>
[QUOTE="sambo3006, post: 373100, member: 2740"] Well, I finally got the cases to go all the way into the die. I made sure there was plenty of sizing wax and short stroked the cases in and out until they were all the way in. After about 15 cases it is somewhat easier but still takes a fair amount of force and short strokes. There might be something to having cleaned out all the lube from the die initially, or maybe the repeated strokes with the cases have lapped the interior of the die a little bit. Either way I am glad that I can resize my cases but I wish there weren't quite so much resistance. Maybe it will get better as I run more cases through it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need suggestions on brass going into sizing die very hard
Top