Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need suggestions on brass going into sizing die very hard
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="406pat" data-source="post: 372943" data-attributes="member: 13575"><p>I would think that annealing would be the next step after making sure that you have the case lube correct. There's a couple kits out there that have temp indicator stuff to put on the case to make sure it doesn't get too hot to get you started getting a feel for annealing. I'd check out midway for one of those then give annealing a shot.</p></blockquote><p></p>
[QUOTE="406pat, post: 372943, member: 13575"] I would think that annealing would be the next step after making sure that you have the case lube correct. There's a couple kits out there that have temp indicator stuff to put on the case to make sure it doesn't get too hot to get you started getting a feel for annealing. I'd check out midway for one of those then give annealing a shot. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need suggestions on brass going into sizing die very hard
Top