Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Need some input on a cartridge I drew up
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="FEENIX" data-source="post: 2173972" data-attributes="member: 14204"><p>For your first concern, be prepared for others' opinions. When I had mine, I just did it.</p><p></p><p>For your second, prices will vary. Go directly to the reamer manufacturer (mine was from Manson's). The same is true for the dies (mine was from Whidden's). "If" you need or prefer a hydraulic forming die, it would be an additional cost (mine was from Whidden's). Good luck!</p></blockquote><p></p>
[QUOTE="FEENIX, post: 2173972, member: 14204"] For your first concern, be prepared for others' opinions. When I had mine, I just did it. For your second, prices will vary. Go directly to the reamer manufacturer (mine was from Manson's). The same is true for the dies (mine was from Whidden's). "If" you need or prefer a hydraulic forming die, it would be an additional cost (mine was from Whidden's). Good luck! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Need some input on a cartridge I drew up
Top