Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need help way way over pressure on near minimum powder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="lancetkenyon" data-source="post: 1573840" data-attributes="member: 68875"><p>Did you chrono your loads? </p><p></p><p>I have done load development on 16 or 17 28 Noslers. I always used to start load development at 85.0gr. Almost every one finishes out at 87-89gr of RL33 to attain 3090-3160fps. I did have one however that had a tight bore and when I started at 85.0gr, I got ejector marks, heavy bolt lift, and almost 3200fps. I ended up at 83.0gr for that particular rifle to achieve a safe load at 3100fps. Cases were within 1gr of every other Nosler brand 28 Nosler brass I have used. Primers were from the same lot, powder was from the same lot.</p></blockquote><p></p>
[QUOTE="lancetkenyon, post: 1573840, member: 68875"] Did you chrono your loads? I have done load development on 16 or 17 28 Noslers. I always used to start load development at 85.0gr. Almost every one finishes out at 87-89gr of RL33 to attain 3090-3160fps. I did have one however that had a tight bore and when I started at 85.0gr, I got ejector marks, heavy bolt lift, and almost 3200fps. I ended up at 83.0gr for that particular rifle to achieve a safe load at 3100fps. Cases were within 1gr of every other Nosler brand 28 Nosler brass I have used. Primers were from the same lot, powder was from the same lot. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need help way way over pressure on near minimum powder
Top