Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Need help on Mueller APT turret settings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Idcastandblast" data-source="post: 745204" data-attributes="member: 56947"><p>This is the first rifle scope that I have set up, and I have a question on the process. It is mounted on my new Rem 700 308 and a 20 moa base. I went to the range and was shooting at 100 yards. I eventually shot the following group, so I was pretty excited.</p><p></p><p>I went home and loosened the screw holding the turret, and reset it to zero on the elevation and windage. In the picture, you can see that the inner indicator for the elevation turret is on 2. On the windage, it is set to 6. </p><p></p><p>Is the inner indicator on the turret supposed to be at zero, just like the outer turret? After looking at it, I am not sure if I needed to crank the turrets all the way so that the inner indicator was on 0 before starting to zero? </p><p></p><p>Put another way, when this scope is zeroed, should the inner and out measurements be on 0?</p><p></p><p>Hopefully the picture does a better job of explaining than I am.</p><p></p><p></p><p>Thanks for any advice.</p></blockquote><p></p>
[QUOTE="Idcastandblast, post: 745204, member: 56947"] This is the first rifle scope that I have set up, and I have a question on the process. It is mounted on my new Rem 700 308 and a 20 moa base. I went to the range and was shooting at 100 yards. I eventually shot the following group, so I was pretty excited. I went home and loosened the screw holding the turret, and reset it to zero on the elevation and windage. In the picture, you can see that the inner indicator for the elevation turret is on 2. On the windage, it is set to 6. Is the inner indicator on the turret supposed to be at zero, just like the outer turret? After looking at it, I am not sure if I needed to crank the turrets all the way so that the inner indicator was on 0 before starting to zero? Put another way, when this scope is zeroed, should the inner and out measurements be on 0? Hopefully the picture does a better job of explaining than I am. Thanks for any advice. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Long Range Scopes and Other Optics
Need help on Mueller APT turret settings
Top