Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need guidance...case neck thickness
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bgbuck153" data-source="post: 1565453" data-attributes="member: 36837"><p>I'm going to get into trimming down my necks to get better consitancy but I'm clueless where to start and what to buy. I don't want to break the bank but just want equipment that will get the job done correctly. Are the hornady lock n load stuff good enough? As far as trimming the necks I'd rather get one that attaches to my drill so my hand doesn't fall off. Ha. I have several hundred LRM cases that need this attention and I was reading about the Sinclair neck sorting gauge and it suggests the brass be NEW... I don't have any new brass.</p></blockquote><p></p>
[QUOTE="bgbuck153, post: 1565453, member: 36837"] I’m going to get into trimming down my necks to get better consitancy but I’m clueless where to start and what to buy. I don’t want to break the bank but just want equipment that will get the job done correctly. Are the hornady lock n load stuff good enough? As far as trimming the necks I’d rather get one that attaches to my drill so my hand doesn’t fall off. Ha. I have several hundred LRM cases that need this attention and I was reading about the Sinclair neck sorting gauge and it suggests the brass be NEW... I don’t have any new brass. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need guidance...case neck thickness
Top