Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice on Concentricity Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Canadian Bushman" data-source="post: 933476" data-attributes="member: 41122"><p>One thing i noticed about reddings bushing dies is that if the bushing has a little slop inside the die its best to keep the lock screw loose than tighten it down. Sometimes it will lock down just a bit off center and translate that into your brass. </p><p>I make most of my own bushings so i run into this problem from time to time. </p><p></p><p>If some of you guys saw how loose i leave certain parts of my dies you would probably think im an idiot. </p><p>The other alternative is to place o-rings under everything. This has the same affect.</p></blockquote><p></p>
[QUOTE="Canadian Bushman, post: 933476, member: 41122"] One thing i noticed about reddings bushing dies is that if the bushing has a little slop inside the die its best to keep the lock screw loose than tighten it down. Sometimes it will lock down just a bit off center and translate that into your brass. I make most of my own bushings so i run into this problem from time to time. If some of you guys saw how loose i leave certain parts of my dies you would probably think im an idiot. The other alternative is to place o-rings under everything. This has the same affect. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice on Concentricity Problem
Top