Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice on Concentricity Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Canadian Bushman" data-source="post: 933464" data-attributes="member: 41122"><p>Thats pretty typical, most brass runs pretty true right out of the chamber. </p><p></p><p>You said earlier that pre loaded necks measure .308 i believe.</p><p>If your fired brass's necks measure >.005 of this value, try sizing it back down in steps. Not to exceed .005 change on the diameter with each sizing. Ive had good luck with this process.</p></blockquote><p></p>
[QUOTE="Canadian Bushman, post: 933464, member: 41122"] Thats pretty typical, most brass runs pretty true right out of the chamber. You said earlier that pre loaded necks measure .308 i believe. If your fired brass's necks measure >.005 of this value, try sizing it back down in steps. Not to exceed .005 change on the diameter with each sizing. Ive had good luck with this process. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Need Advice on Concentricity Problem
Top