Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
necking down 7saum to 6.5 gap
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="clownbuster" data-source="post: 1478833" data-attributes="member: 22486"><p>To answer your question, yes, you have to turn the necks afterwards. When sizing down brass, you're forming neck material from the shoulder which is thicker, which creates a thick spot, or "donut" at the newly-formed neck-shoulder junction that must be either reamed out from the inside of the neck, or expanded and turned off of the outside of the neck.</p></blockquote><p></p>
[QUOTE="clownbuster, post: 1478833, member: 22486"] To answer your question, yes, you have to turn the necks afterwards. When sizing down brass, you're forming neck material from the shoulder which is thicker, which creates a thick spot, or "donut" at the newly-formed neck-shoulder junction that must be either reamed out from the inside of the neck, or expanded and turned off of the outside of the neck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
necking down 7saum to 6.5 gap
Top